XPL200 stands

[brett_s]

Hello,
I am hoping someone is willing to help me out with finding some information. I have been trying to find a set of factory stands for the XPL200 (stand part #MTX200) but have not had much luck. They are very hard to find not already married to a set of speakers, and no ever wants to separate them.
With that said, I do have the ability to fabricate a set that would be very similar to the factory ones. I would likely change the way they are assembled, but from an aesthetics standpoint, I could make them very similar (except for the JBL logo on the front).
However, I have no dimensions and only a few pictures I’ve downloaded from this site on them. If I could get a few crucial dimensions, a couple pictures, and perhaps a tracing of the top and bottom plate (so I could accurately duplicate the radiuses and angles), I would be able to make a set that at first glance would look like the originals. An engineering print would be even better….but I won’t hold my breath.
Let me know if anyone is interested in helping me out. I know it’s a lot to ask, but I figured I’d give it a shot.
Brett

[brett_s]

looks like I'm going to strike out on this....

[gferrell]

I would help but all I have are XPL 160 stands

[pasadena]

57576575775757857579

[pasadena]

575815758257583

[pasadena]

57585

[pasadena]

This is the best I can do without providing dimensions, apart from dissembling the stands, there's not much I can do. I can try and run a ruler around the stands as they sit.

Cheers

[brett_s]

That is quite helpful. Would it be possible to get a few dimensions? i've marked up your pictures with what I'm looking for.

Would it be possible to get a picture directly from the side as well?

i appreciate your help, If I can get these dimensions, I think I should be able to fill in the blanks, to make them very similar to stock, if you can provide these dimensions.

Thank you so much,
Brett