PDA

View Full Version : N500C Network Divider



mvrandazzo
02-27-2010, 03:56 PM
Hello All,
I ran across this forum doing research on an Altec Lansing array installed in a theater. It was disconnected for an unknown reason. I would like to get it going and I am looking for documentation on the N500C network divider. It is connected to 4 288C drivers and 2 15" cabinets that are unknown. I temporarily hooked it up to an 8 ohm source to see if it still works and it sounded great. However, I did not leave it hooked up for fear the impedance is incorrect. I found some info on the N500F but I don;t know if it is the same as the N500C. Is there a schematic on the N500C.

Thanks.
Mark :D

jcrobso
03-01-2010, 09:43 AM
http://alteclansingunofficial.nlenet.net/publications/techletters/TL_121.pdf

kstlfido
01-08-2014, 06:47 PM
I just came across one and needed the schematic to check it out. Thanks for the link!