PDA

View Full Version : 802 driver mounting bolt



Zuben
11-23-2009, 11:37 PM
I have an 802 driver that one of the 2 mounting bolts snapped off even with the driver case. Does anyone know if this is a single threaded insert or a bolt with the head in the casing.

Is it posible to use a screw extractor to remove the embedded thread and replace it?

Thanks you.
Mike

robertbartsch
11-24-2009, 01:58 PM
The bolt is really a stud without a head.

Anyway, this happened to me also. I drilled the busted stud out using a drill press. If you can file the busted stud flat it helps. Use a tap to mark the center of the stud helps too.

Use a new small drill that is extra sharp. You can prep it by using some liquid wrench.

I found a replacement from the Depo store; take the busted stud and with you and match it up.

Tim Rinkerman
11-25-2009, 05:52 AM
Make sure you cover the throat with tape before you start drilling.....

Zuben
11-25-2009, 11:09 PM
Thanks!

I was hoping that it was a stud. I have a set of srew extractors that should work just fine. I just found a supply of stock copy binding posts and fixed a few that were missing posts.

Now I can get on with my modified dual 15" Altec driver JBL scoop cabinets. I wanted it as factory as I could get it. :applaud:

Mike