View Full Version : 2" driver ID help please?
Don Mascali
07-25-2009, 10:22 AM
I can't find anything that resembles this. Any ideas?
Thanks,
Don M
Mr. Widget
07-25-2009, 01:42 PM
I don't recognize it either. That back cap looks pretty inexpensive, or is it die cast aluminum? I would look at the lower cost drivers... here is an extensive photo list of drivers, it looks closest to a JBL 2445/2446 with the nose cut off. I wonder if it is a Chinese clone of one.
Are you sure it isn't a 1.5" exit 2447? I have never seen one in person, but it looks like it could be that driver or a clone of it.
http://www.usspeaker.com/hfcompressiondrivers-1.htm
Widget
Don Mascali
07-25-2009, 02:35 PM
The cap is aluminum or pot metal and rings like a bell when you snap it with your finger. I bet it does the same when it plays too.
The JBL 2447 and others have three indents for screws, this has four. Your clone idea looks like a real posibility.
Thanks for the link.
subwoof
07-25-2009, 02:38 PM
It's the Taiwanese 2447 clone by Paudio and had many nameplates.
Don Mascali
07-25-2009, 08:39 PM
Thank you!
I knew you guys would get.
spkrman57
07-26-2009, 12:22 PM
Lookes really close to my EV DH1-A 2" compression drivers.
Regards, Ron
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.