View Full Version : Just bought Altec Lansing Nine Series II
dcastle42
03-31-2009, 08:48 AM
The 5 1/2 Mids are in need of reconing or replaced i stuck a set of Daton Mid i had laying around but would like to find a set of orignal mids any ideas where i could find a set . There stained black but look very good
not sure how to put a Picture in
Thanks Dennis
MikeBrewster77
03-31-2009, 08:58 AM
I replied to your earlier post in the other thread.
... congrats on your purchase.
Re: the Altec Lansing 9 Series II, I could be wrong, but I think the mids are 6.5" on these...
http://www.lansingheritage.org/image...ome/page04.jpg (http://www.lansingheritage.org/images/altec/catalogs/1978-home/page04.jpg)
Not sure where you might pick up a set of replacements, except perhaps an online auction site. Are they beyond a recone?
The 5 1/2 Mids are in need of reconing or replaced i stuck a set of Daton Mid i had laying around but would like to find a set of orignal mids any ideas where i could find a set . There stained black but look very good
not sure how to put a Picture in
Thanks Dennis
boputnam
03-31-2009, 11:53 AM
...not sure how to put a Picture in
Go to "FAQ" at the top, left.
Then to General Forum Usage.
Then to Attachments and Images (http://audioheritage.csdco.com/vbulletin/faq.php?faq=vb3_reading_posting#faq_vb3_attachment s) - it's all there.
The struggle will be sizing the image to within the limits tolerated.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.