View Full Version : Jumper Gage 9444B Amp
Zuben
01-31-2009, 01:57 PM
Does anyone knowthe jumper (wire) gage used for the Octal sockets on the back of the 9444b amp?
Thanks
Mike
hmolwitz
02-01-2009, 07:53 PM
As long as it makes good contact I wouldn't worry too much, I used 14 ga solid copper, scraps pulled from romex, if you want to get fancy you can buy a couple of octal sockets and jumper the sockets, I got the plug in crossovers, neat if you can find them.
Harry
Zuben
02-07-2009, 05:26 PM
Thanks,
Thank is what I figured I do. I have a 9333B I picked up with 70v octals.
Mike
Zuben
02-07-2009, 10:36 PM
I was wondering is I should just leave the 15015A's in place.
The module says bridging transformer but all the lit I have read says it is a Input Balance
I have 4 of these amps running mains and monitors for a band. Only 1 amp has the 15015A modules. (One is an EV but the same amp)
Is there any advantage leaving them in?
Mike
hmolwitz
02-08-2009, 08:32 AM
I am absolutely unsure of the function of those 15015A input bridging modules, I am sure they do something to your signal, try posting on the Altec Users group.
http://www.hostboard.com/forums/forumdisplay.php?f=706
Best
Harry
Zuben
02-08-2009, 11:47 AM
Harry,,
Your link deadends. I did a google on Altec User Groups and didn't see a URL close
Thanks
Mike
Goodwill_HiFi
02-09-2009, 01:30 PM
Harry,,
Your link deadends. I did a google on Altec User Groups and didn't see a URL close
Works fine for me..... must be just you :)
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.