PDA

View Full Version : XPL200 Tech sheet



Don C
05-09-2004, 04:00 PM
Has anyone got the tech sheet for the XPL-200? I have the sheet for XPL200A, I am trying to find the sheet for the earlier version.

4313B
05-10-2004, 01:20 PM
If I ever saw an XPL200 tech sheet it was very briefly.

Known differences:

XPL200
095Ti (aluminum wire)
046Ti (aluminum wire)
0 dB and +2 dB UHF switch.

XPL200A
093Ti (copper clad aluminum wire)
046Ti-1 (copper clad aluminum wire)
-2 dB and 0 dB UHF switch.

Don C
05-10-2004, 02:19 PM
That helps. I was most curious about the networks, and if there are changes to accomodate the change in the drivers. I will be bringing home a pair of the early version later this week, and I already know that I need to replace the midrange on one speaker. No problem, since I have a pair of 093Ti ready to go. But that raises the question of whether I should install 200a networks as well. I do have a set of those available. And then if I do that, do I need to go ahead and order new tweeters (or diaphragm kits) as well?

4313B
05-10-2004, 03:43 PM
Let's compare networks as soon as you bring home the XPL200's ok? Pictures would be nice too. :)

I'm anxious to see what you think of the XPL's.

andresohc
05-10-2004, 04:01 PM
Is there any way to tell the difference between the 093ti and the 095ti. I have a pair of what I believe are 093tis, with no markings on the back. Is the DCR the same?

Don C
05-10-2004, 06:55 PM
"Is there any way to tell the difference between the 093ti and the 095ti."

I may be able to figure that out when I have the two side by side. We'll see. Mine have a 093Ti sticker on the back. I think that there is a car stereo version of these too.

gerald
11-12-2004, 03:39 AM
Hello!
I leave in France and i have XPL 200 with 095TI
Best regards

Gerald Challon