Guenter
12-11-2008, 06:03 PM
Hi All,
I obtained a set of empty L200b cabinets and have a variety of drivers available to place in them. I'm a bit unsure of which to use so as to create an optimal system. So:
1) should I use a 375 or 85 mid driver, the latter with long or short horns. I'm concerned that the 375's might be too heavy and create excessive torque on the front panel. re the long or short horns, I do like the long horn more, but is the longer delay time vis a vis woofer and tweeter too severe a penalty... not sure.
2) I've got LE15a woofers and 2235 (I think that's the #'s or close to that) ferrite newer ones. I'm thinking I should go with the ferrites.
3) plan to drill a hole for either 075 or 077 tweeters. Should I drill the hole centrally in the middle above the 375's or mirrored to one side. Is the 075 possible a better much to the 375's ? I'm thinking similar vitage etc may be important.
any suggestions and/or guidance much appreciated
cheers, guenter
I obtained a set of empty L200b cabinets and have a variety of drivers available to place in them. I'm a bit unsure of which to use so as to create an optimal system. So:
1) should I use a 375 or 85 mid driver, the latter with long or short horns. I'm concerned that the 375's might be too heavy and create excessive torque on the front panel. re the long or short horns, I do like the long horn more, but is the longer delay time vis a vis woofer and tweeter too severe a penalty... not sure.
2) I've got LE15a woofers and 2235 (I think that's the #'s or close to that) ferrite newer ones. I'm thinking I should go with the ferrites.
3) plan to drill a hole for either 075 or 077 tweeters. Should I drill the hole centrally in the middle above the 375's or mirrored to one side. Is the 075 possible a better much to the 375's ? I'm thinking similar vitage etc may be important.
any suggestions and/or guidance much appreciated
cheers, guenter