View Full Version : Jbl Le-10-101
kegger
10-29-2008, 07:09 PM
Anyone know much about these.
http://cgi.ebay.com/ws/eBayISAPI.dll?ViewItem&rd=1&item=260284001105&ssPageName=STRK:MEWN:IT&ih=016
On a whim and a nudge, I bought them. :)
Now I need to figure out what to use them in once they get here.
jackgiff
10-29-2008, 07:36 PM
EconoWave, of course. :rockon1:
kegger
10-30-2008, 01:42 AM
Ha Ha! :applaud:
More then likely that would be the use.
If these actually model up like an LE10A does in winisd I like what I see. :thmbsup:
Earl K
10-30-2008, 08:35 AM
Hi Kegger,
Anyone know much about these?
- In 5 or 6 years of hanging out at various LHF forums, I've never seen accurate , published TS numbers ( for this le10 variant ) .
- My guess is it's an le10a voice-coil married onto a 2121a cone . If my guess is correct the published ( le10a ) parameters will be off by quite a bit . It'll be more a mid-bass transducer ( than a real le10a ) .
- I'd recommend sending those units to Gordon W for refoaming and parameter testing ( or buy yourself Woofer Tester 3 and do the measurements yourself / to keep this all in the DIY realm ) .
- FWIW; you'll likely need to add mass to those cones to get them to act as bonafide le10a woofs . Again, Gordon can do this for you .
<> Earl K
kegger
10-30-2008, 08:48 AM
Thanks Earl,
Yep have access to 2 different Woofer tester 3's, when they do get refoamed
I'll take the measurements an post the results. I should be able to refoam them.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.