PDA

View Full Version : 3110A crossover problem



jbl
03-05-2004, 12:01 PM
Hi all,
Anyone know of the following. The 3110A crossover uses rivits that hold the two halfs of the unit together. The posts tend to come loose and the only way to tighten them is to disassemble the unit and tighten the posts. This is'nt a problem. The problem is that JBL used rivits. The rivits once drilled out are'nt reuseable. Any suggestions on what to use?

jbl-

JuniorJBL
03-05-2004, 12:18 PM
You could use a new rivit (they sell them at most home centers for very cheep around $15-20 for a gun and some rivits) or you could get some Tinnerman nuts(clip nut) and use some short screws. A rivit might be best if the crossover has to slide in a hole cut out for the box.
Shane:D

subwoof
03-05-2004, 02:51 PM
#6 by 1/2" sheetmetal screws. drill out the rivets

sub

and the frog says rivit, rivit...:)