PDA

View Full Version : Intermittant continuity on tranducer - what's wrong?



doyall
07-16-2007, 07:58 PM
I have a transducer (115H) that occasionally has continuity and therefore works intermittantly. It seems to have continuity/work only when inward pressure is applied to the cone. The tinsel lead is securely attached to the connector terrminal and all other visable items seem intact. Anybody have a similar experiance and reach a conclusion as to what the problem was? Is there any repair possible or is it fatal?

pelly3s
07-16-2007, 09:50 PM
most likely the lead wires need to be touched up. try first at the terminals even though they look ok, i have done probably 10 pairs of them on 115's. if that doesn't help then the problem is where the tinsel wires meet the coil leads.