jmai
02-09-2004, 04:23 AM
What is the width of the gap supposed to be on a 2482? Is there a tolerance specified?
I suspect that the driver I have that is 1mm on one side and 1.4mm on the other is way out of spec.
Is it possible to adjust this without degaussing by shifting the top plate somehow?
Thanks for any advice.
I suspect that the driver I have that is 1mm on one side and 1.4mm on the other is way out of spec.
Is it possible to adjust this without degaussing by shifting the top plate somehow?
Thanks for any advice.