PDA

View Full Version : Reconing jbl eon15



karyoker
06-08-2007, 05:31 PM
Ok Ive laid carpet drywalled built cabinets overhauled engines and was in electronics 40 years.

How hard is it really to recone an eon15? Are there any tricks or pitfalls I should be aware of? I am putting in the whole kit eon15-g2LF..

SMKSoundPro
06-09-2007, 01:02 AM
Welcome to the forum.

It is a very straight forward recone.

We have JBL reconers here on the site.

Shout out to EdgeWound, or others.

If in doubt, Take it to a JBL Service Center in your area.

Hope this helps.

Scott.

pelly3s
06-17-2007, 06:03 AM
the c2reon15p-2 is the kit number. i can tell you that I have had a couple of them where the spider didnt take the glue all too well and came loose which requires opening the whole cabinet again. it is a little harder to clean the surface the spider sits on as it is in tight quarters. other than the time it takes to take the whole cabinet apart and put it back together its all and all not a hard job to do