bought pair P10's today , question

[SEAWOLF97]

Don't ask. I don't remember where or how much :blink:

But the little pups sound pretty nice , great condition.
I looked up the PDF and everywhere that it says "titanium HF" it is XXXX'ed out . Was that spec a mistake on the PDF or did they change design specs ? Havn't removed HF , but they look like titanium (right color)...preplexed. :blink:

this is all I cud find on the web


First Manufactured 1992
Last Manufactured 1993
Recommended Power Amplifier Range 10 - 50 watts
Nominal Impedance 6 ohms
Woofer 5.25" fiber cone
Tweeter 0.5" vapor deposited titanium dome
Frequency Response 70Hz - 20kHz
Crossover Frequency(ies) 3.5kHz
Sensitivity 87dB (1 watt/1 meter)

[SEAWOLF97]

more....

Also got one of these ...adc ss310 EQs
no manual ...anybody know how to use the mike i/p and pink noise generator ?

[johnaec]

You need to connect a flat-response, (calibrated), mic to the input, and when you press the pink noise button, it should send pink noise to the inputs of your amp via the outputs of the EQ. Theoretically, the display should then be showing what the mic is hearing, and you'd adjust the EQ for flattest response.

John

[Don C]

You can fool with the ADC if you like, but don't get your hopes up. I had one similar to that years ago, when I adjusted it so that it looked flat on the analyzer, my system sounded awful. I got rid of it pretty quickly.

[SEAWOLF97]

Havn't removed HF , but they look like titanium (right color)...preplexed. :blink:


pulled the Hf out ....on the face it says "JBL XE"

on rear
two14d08
100752a
02702

Is one of those numbers a model number ?

[SEAWOLF97]

You can fool with the ADC if you like, but don't get your hopes up. I had one similar to that years ago, when I adjusted it so that it looked flat on the analyzer, my system sounded awful. I got rid of it pretty quickly.

I usually tune "by ear , to taste" . Set it up this morning , works great as an EQ and lightshow.