View Full Version : Will It Go 'Round In Circles...(circle cutting)
Charley Rummel
07-28-2006, 06:06 PM
Hi, Everyone:
Here's one I must inquire about:
How do you like to cut your openings for your speakers/drivers? There's many ways out there...how do you do it?
Regards,
Charley
edgewound
07-28-2006, 06:16 PM
Hi, Everyone:
Here's one I must inquire about:
How do you like to cut your openings for your speakers/drivers? There's many ways out there...how do you do it?
Regards,
Charley
Definitely a router...preferably plunge router...a good one....Milwaukee, Porter-Cable, Bosch, DeWalt.... 2 hp+, carbide bits.
Use a template with a pilot bearing or a circle jig by Jasper or make one.
loach71
07-28-2006, 06:45 PM
I like using the MicroFence system for my routers - includes circle cutting, ellipse cutting, precision plunge etc.
http://www.microfence.com/pages/welcome.html
Don Mascali
07-29-2006, 03:27 AM
Here is a how to thread on a Jasper Circle jig.
http://audioheritage.org/vbulletin/showthread.php?t=10047&highlight=jasper
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.