Register
Help
Remember Me?
Forum
What's New?
Activity Stream
New Posts
New Events
Mark Forums Read
Main Website
Library
Photo Gallery
Advanced Search
Home
Activity Stream
If this is your first visit, be sure to check out the
FAQ
by clicking the link above. You may have to
register
before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.
Activity Stream
Filter
Sort By
Time
Show
Recent
Recent
Popular
Popular
Anytime
Anytime
Last 7 Days
Last 7 Days
Last 30 Days
Last 30 Days
All
All
Photos
Photos
Forum
Forums
New Activity (
)
Please reload this page to view the 200+ new activity items that have been created.
Older Activity
Today,
10:55 AM
Robh3606
replied to a thread
Affordable Preamps & amplifiers? Thoughts on Carver Gear?
in
General Audio Discussion
I don't go through a lot of gear I tend to like and keep. I have either Crowns or Emotiva in all my systems. My HT is a mix of Crown and Emotiva. I...
see more
17 replies | 185 view(s)
Today,
10:36 AM
Robh3606
replied to a thread
Affordable Preamps & amplifiers? Thoughts on Carver Gear?
in
General Audio Discussion
Hello BMWCCA Yes I can only think of one time I could get those comparator lights to flash on any of them. My PS400 was driving stereo subs and I...
see more
17 replies | 185 view(s)
Today,
10:28 AM
Mr. Widget
replied to a thread
My time with the 4343
in
Lansing Product General Information
Keep going, the journey is often even better than the destination! Widget
see more
3 replies | 25 view(s)
Today,
10:25 AM
Mr. Widget
replied to a thread
My time with the 4343
in
Lansing Product General Information
John Eargle was another great man at JBL. His long list of accomplishments and contributions to audio recording and reproduction are only touched...
see more
3 replies | 25 view(s)
Today,
10:05 AM
DerekTheGreat
replied to a thread
Opinions wanted: 240Ti vs L-150A
in
Lansing Product General Information
CD will do, that's how I listen. I do have a turntable but I don't rock out when I play records. I have yet to do vinyl vs CD. Although the videos...
see more
42 replies | 2839 view(s)
Today,
10:01 AM
DerekTheGreat
replied to a thread
Affordable Preamps & amplifiers? Thoughts on Carver Gear?
in
General Audio Discussion
Could you be persuaded to part with a few of your spare PS400's, say two of them? Which other amps did you try against the Crowns and what is about...
see more
17 replies | 185 view(s)
Today,
09:52 AM
DerekTheGreat
replied to a thread
My time with the 4343
in
Lansing Product General Information
IF that photo is him, he doesn't strike me as the kind of guy who cares or looks behind him. If John has commented on this forum, I'm not aware....
see more
3 replies | 25 view(s)
Today,
09:06 AM
Goldjazz
started a thread
My time with the 4343
in
Lansing Product General Information
Six years ago I went on a 600 mile road trip with two friends to pick up a pair of 4343's. It was a fun trip :). Since then I've experimented with...
see more
3 replies | 25 view(s)
Today,
08:07 AM
Robh3606
replied to a thread
Passive Monitor Thread
in
Lansing Product DIY Forum
Hello Thanks! They use a 270us delay to time align them using the DSP for the M2. So no they don't align you would have to push back the horn...
see more
154 replies | 42453 view(s)
Today,
05:15 AM
BMWCCA
replied to a thread
Affordable Preamps & amplifiers? Thoughts on Carver Gear?
in
General Audio Discussion
I have several PS400s and PS200s. My main system powering the 4345s uses one of each. Liked them enough to keep spares. Doubt I ever paid over $200...
see more
17 replies | 185 view(s)
Today,
05:02 AM
DerekTheGreat
replied to a thread
Affordable Preamps & amplifiers? Thoughts on Carver Gear?
in
General Audio Discussion
Looks like neat old gear, but too ancient.. That said, my Marantz 3600 is long in the tooth too. But, without the fuzzy 510M, it's actually a...
see more
17 replies | 185 view(s)
Today,
02:27 AM
Kay Pirinha
replied to a thread
Why DD67000 and K2-S9900 just don't matter...
in
Lansing Product General Information
Hi, the music in this video is as boring, for not to say annoying, exactly as these advertised lifestyle products are. Not even Lang Lang gets...
see more
17 replies | 801 view(s)
Today,
01:57 AM
RMC
replied to a thread
Affordable Preamps & amplifiers? Thoughts on Carver Gear?
in
General Audio Discussion
Depending on one's needs and budget, some other & maybe more affordable preamp ideas, those are MADE IN THE GOOD OLE USA (note that Bellari is a...
see more
17 replies | 185 view(s)
Today,
01:46 AM
jmpsmash
replied to a thread
Passive Monitor Thread
in
Lansing Product DIY Forum
Incredible build and love that finish! With the shallow depth of the M2 horn and the relatively deep 2216ND, did you measured if JBL designed them...
see more
154 replies | 42453 view(s)
Yesterday,
11:22 PM
VinylGroove
replied to a thread
JBL 250TI powered by Outlaw 110W Receiver?
in
General Audio Discussion
Well, I found a great Parasound preamp and amplifier from a forum member that should fit the bill very well. Thank you
see more
3 replies | 58 view(s)
Yesterday,
10:46 PM
audiojunkman
started a thread
Looking for Altec A255 schematic
in
Lansing Product Technical Help
Looking for a schematic or service info for an Altec A255 Amplfier. Thanks!
see more
0 replies | 13 view(s)
Yesterday,
10:21 PM
jmpsmash
replied to a thread
Building my dream system, need lots of advise!
in
Lansing Product DIY Forum
Agree. They sound very good, but probably a bit beyond their prime and not in their best performance. I do like the sound of the combo, so much...
see more
218 replies | 44151 view(s)
Yesterday,
10:00 PM
1audiohack
replied to a thread
2215A+PR15 vs 2235H vs 1500FE vs 2265HPL vs 2255HPL
in
Lansing Product DIY Forum
For sure! Barry.
see more
3 replies | 98 view(s)
Yesterday,
09:57 PM
JeffW
replied to a thread
Building my dream system, need lots of advise!
in
Lansing Product DIY Forum
...and why anybody contemplating a build from new-ish JBL should invest in a backup set of parts. Last time I looked, even things like 2405...
see more
218 replies | 44151 view(s)
Yesterday,
09:38 PM
Mr. Widget
replied to a thread
Building my dream system, need lots of advise!
in
Lansing Product DIY Forum
Got it. Yes, we often hear people's reviews of vintage speakers, drivers, and electronics... if you can't verify that they are up to spec, then you...
see more
218 replies | 44151 view(s)
Yesterday,
08:37 PM
jmpsmash
replied to a thread
Building my dream system, need lots of advise!
in
Lansing Product DIY Forum
Yeah. I just placed order for D2430K + STX825. I am not the patience type. :applaud:
see more
218 replies | 44151 view(s)
Yesterday,
08:26 PM
Ian Mackenzie
replied to a thread
Building my dream system, need lots of advise!
in
Lansing Product DIY Forum
Your just going to have to try it yourself
see more
218 replies | 44151 view(s)
Yesterday,
08:22 PM
jmpsmash
replied to a thread
Building my dream system, need lots of advise!
in
Lansing Product DIY Forum
That's a great thread. Pretty close to what I am envisioning. I am gonna try the STX825 first, quite a bit more affordable to start.
see more
218 replies | 44151 view(s)
Yesterday,
08:21 PM
jmpsmash
replied to a thread
Building my dream system, need lots of advise!
in
Lansing Product DIY Forum
for both driver, both frequency response and impedance measurements, measured from REW and DATS respectively, don't match. Probably due to diaphragm...
see more
218 replies | 44151 view(s)
More Activity
No More Results
No Recent Activity