Activity Stream

Hello Thanks! They use a 270us delay to time align them using the DSP for the M2. So no they don't align you would have to push back the horn...

I have several PS400s and PS200s. My main system powering the 4345s uses one of each. Liked them enough to keep spares. Doubt I ever paid over $200...

Looks like neat old gear, but too ancient.. That said, my Marantz 3600 is long in the tooth too. But, without the fuzzy 510M, it's actually a...

Hi, the music in this video is as boring, for not to say annoying, exactly as these advertised lifestyle products are. Not even Lang Lang gets...

Depending on one's needs and budget, some other & maybe more affordable preamp ideas, those are MADE IN THE GOOD OLE USA (note that Bellari is a...

Incredible build and love that finish! With the shallow depth of the M2 horn and the relatively deep 2216ND, did you measured if JBL designed them...

Well, I found a great Parasound preamp and amplifier from a forum member that should fit the bill very well. Thank you

Agree. They sound very good, but probably a bit beyond their prime and not in their best performance. I do like the sound of the combo, so much...

For sure! Barry.

...and why anybody contemplating a build from new-ish JBL should invest in a backup set of parts. Last time I looked, even things like 2405...

Got it. Yes, we often hear people's reviews of vintage speakers, drivers, and electronics... if you can't verify that they are up to spec, then you...

Yeah. I just placed order for D2430K + STX825. I am not the patience type. :applaud:

Your just going to have to try it yourself

That's a great thread. Pretty close to what I am envisioning. I am gonna try the STX825 first, quite a bit more affordable to start.

for both driver, both frequency response and impedance measurements, measured from REW and DATS respectively, don't match. Probably due to diaphragm...

Can you elaborate? Widget

Good luck with that I doubt you are going to find 4 PS-400. I have 1 PS400 and 6 PS 200 in service. The PS 400 and 3 PS 200 in my HT and 3 in a...

Hi Ian, The 4367 passive crossover was posted in one of the thread. I looked at it. One of the poles essentially started around 8kHz which...

I like your "buy once and cry once" comment:) When we sold 250Ti's at retail we demo'd them with a Harman Kardon stack that wasn't much power...

Wow!! Those look fabulous! And you made them yourself.. amazing. I think that there is a thread here on the 3100 built by Mathias. Somewhere there...

I also have 250Ti's .... tried on a 110wpc Denon receiver ... that was OK , but they really came alive with a 375wpc BGW amp.

Have a talk to Rhob who recently did a passive monitor thread I have not tried my M2 horns yet. What you will find is that the passive...

HCSGuy: Well, I'm not ready to take my speakers apart to check that out; quite the job! The treble sounds just fine to ME, so I will leave good...

I have a BGW 203 . had a tantulum cap changed a while back ... tech was impressed "it is build like MILSPEC with high qual components" ... it has...