Activity Stream

Hello Rusty It's a weird shaped room with a large walk in closet filling one corner. One speaker is close but better the other has no wall close....

These polars are normalized for 0dB at 0°, so frequency response is not part of the equation here. Directivity cannot be changed with DSP (well,...

I don't think you need DSP just use the original passive compensation in bi-amp mode. Look at the polars! ...

Chapeau .... c'est vrai .. Mac

I have never heard or measured a "modernized" (ie with a properly implemented DSP crossover) set of 4430, but from the technical info I can gather...

Cone material is one thing. Dual differential drive, low TCR voice coils to combat power compression, better adhesives, higher power handling and...

you can see where the speaker connections are in this pic. I clipped the wires to reuse. The red and black attached to terminal cup.

Photo

Lf cones are still made from paper and aluminium is still widely used ( and sometimes preferred) in compression drivers.Through research, materials...

From the cutaway part of a JBL brochure they show the vented VC. This must of been a bad recone and they used the dome glue as the main glue...

I coulda stated I have and use on my builds and rebuilds the Owens Corning 703 insulation. Also I have a set of JBL 2226HPL as well.

Rob, do you have a picture of the new positioning? I'm not sure how long the long wall is but the speakers were definitely too close to the side...

Well if your space is that big I would go full unfolded horn anyways. That's the king route if the space is there...

Has anyone ever compared the PT800/PS1400 to the Studio 590 speakers (also a work of Greg Timbers)? People seem to rave about them online, so I'm...

Hi club900fe, I would suggest to contact by email, as it was written in the:( rcobb@tampabay.rr.com ) ...

Some may already know, others may not, but Dynaco (and Hafler) were revived by Canada's Radial Engineering in Vancouver region. (radialeng.com) As...

Photo of the other side of this would be helpful

The big hurdle will be finding the 2342 horns, and then adjusting the low pass of the crossover for that woofer. There are other horns you may find...

I have access to a pair of 123a woofers and have contemplated a similar project. My thought was to use the crossover form the L 200t3 as a basis....

Have heard here suggestions, there are better choices for mid than 2216Nd. What choices I have? Please suggestions, who knows. New models,...